Email senden | Tel. 0049 681 5898 564


ServiceRepair ServiceArtist RelationsImpressumGalleryLinksNewsletterVersandkostenUsed Gear

loopersparadise
loopersparadise
Home  / Webshop  / Effects  / Vahlbruch FX Effects  / 
px
 OptoTrem Tremolo Pedal
Artikel bestellen
Vahlbruch FX Effects
OptoTrem Tremolo Pedal
Artikel Nr. 2760
EUR 199,00  
inkl. MwSt.
Versandkostenfrei innerhalb Deutschlands
Versandkosten international..
Auf Lager


Vahlbruch FX Effects: OptoTrem Tremolo Pedal
OptoTrem Tremolo Pedal

The "OptoTrem" is an analog, hand-build, highly versatile tremolo effect pedal and one of the finest studio quality tremolos in existence. "Opto-Trem" offers you authentic sine-wave 60`s vintage tremolo sounds as well as modern square wave helicopter chop effects. Its unique circuit is carefully designed around a photocell and it shows super low electronic backgroundnoise. For an especially deep and homogenous modulation curve only handselected photocells are used for the "OptoTrem" and each pedal is hand-trimmed to this specific opto-cell. The "Speed" and "Intensity" knobs control modulation rate and depth, a toggle switch allows to select either a "hard" or "soft" modulation curve. The pedal output level can be adjusted using the "Volume" control. A constantly fashing amber LED indicates your adjusted modulation speed and depth, even when the pedal is in bypass to easily match the song tempo.
NOTE: The "OptoTrem" also works as a great clean boost with "Intensity" control turned down!

This pedal is equipped with our unique "MagTraB" switching technology:
Inside the button a magnet is integrated which position is measured by a sensor on the circuit board. If the button is now moved, e.g. if it is pressed downwards, the position of the magnet will also change. The sensor measures this change without any mechanical contact to the button and the information is send via a micro-controller to a gold-plated relay, which then does the actual audio signal switching.

The advantages of "MagTraB" footswitches:
MapTraB buttons are as good as indestructible! "MagTraB" delivers an almost infinite number of switching cycles - many, many millions!
No annoying, mechanical switch clicks! Instead, the "MagTraB" push-buttons switch very smooth and silently!
You can choose if the pedal powers up in "on" or "bypass" state.
To change the state:
Step 1: Unplug the power supply cable.
Step 2: Hold down on/off "MagTraB" button.
Step 3: Plug in again the power supply cable.
Step 4: Release on/off "MagTraB"" button.
DONE! The next time your pedal powers up it will automatically start in the other state.

Specifications:
Unique MagTraB switching technology
Hand selected photocells for a deep and homogenous modulation curve
Super low noise circuit
"Volume" controls the pedal output level
"Speed" regulates the modulation rate
"Intensity" adjusts the modulation depth
Toggle switch to select between "hard" or "soft" modulation curve
Constantly pulsating LED indicates the speed and depth of modulation
The "OptoTrem" also works as an incredible clean boost with the "Intensity" control turned down!
Input impedance: 1M Ohms
Output impedance: 220 Ohms
Current consumption: 40mA
This pedal requires an external regulated 9V power supply (not included), polarity: positiv@ring / negative@tip
Dimensions: 115mm x 70mm x 48mm
Weight: 240g
Handmade in Germany

Preise inkl. der gesetzlichen MwSt. Satzfehler und Irrtümer vorbehalten. Lieferung von Ware am Lager solange Vorrat reicht. Preise in € zzgl. Versandkosten.
© Frank Post, Bruchwiesenstrasse 25, D-66111 Saarbrücken, Telefon 0049(0)681-5898564, Email info AT loopersparadise de




CMS Content-Management & Webshop-System

Page built in 0.035 Sec.